2N Lift8 Короткий посібник - Сторінка 10

Переглянути онлайн або завантажити pdf Короткий посібник для Блок управління 2N Lift8. 2N Lift8 14 сторінок. Io module
Також для 2N Lift8: Короткий посібник (8 сторінок), Короткий посібник (12 сторінок), Короткий посібник (13 сторінок), Короткий посібник (6 сторінок), Короткий посібник (12 сторінок), Короткий посібник (17 сторінок)

LED indicators

The camera module is equipped with seven LED indicators; see the table below.

Name

Colour

The LED is flashing while images are being recorded on the microSD card.

Orange

When the LED is on, you can slide the microSD card out by pressing the

REC/STOP button.

REL

undefined not implemented

The LED is flashing to indicate that the bus is connected and the camera

module is communicating with the CU. The LED is illuminated when an alarm

call is being set up. The LED is flashing quickly when a camera image is being

Green

loaded during an alarm call.

The LED lights up for a moment to indicate bus connection. The LED is

flashing slowly to indicate a collision with another module (make sure that

ERR

Red

just one camera module is connected for the given shaft).

The LED is on when the camera is connected and configured properly. The

ETH

Orange

LED is flashing to indicate active recording.

The LED is on when the camera is connected and configured properly. The

232

Orange

LED is flashing to indicate active recording.

The LED is on when the camera is connected and configured properly. The

485

Orange

LED is flashing to indicate active recording.

Caution

The OK LED is flashing and ERR LED is illuminated when the unit is being



upgraded.

Caution

Use the 2N



parameters.

Camera Module Setting

Set the 2N® Lift8 camera module via the 2N® Lift8 Service Tool. Refer to 5.3 Use for

details.

Lift8 Service Tool application to set the camera type and other

Description