AEG ATB8101VNX Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера AEG ATB8101VNX. AEG ATB8101VNX 16 сторінок.
Друкувати сторінкуProblem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The door is not closed cor-
rectly.
The FROSTMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Food products are not wrap-
ped properly.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The FROSTMATIC function
is switched on.
The appliance is not level-
led.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FROSTMATIC function
is switched on.
ENGLISH
Solution
Refer to "Closing the door".
Refer to "FROSTMATIC
function".
Refer to "Closing the door".
Wrap the food products bet-
ter.
The compressor starts after a
period of time.
Attach the melting water
outlet to the evaporative
tray.
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function"
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
11