AEG OKO-ARCTIS 3193-4GA Інструкція з експлуатації Посібник з експлуатації - Сторінка 27
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Морозильна камера AEG OKO-ARCTIS 3193-4GA. AEG OKO-ARCTIS 3193-4GA 40 сторінок. Electrolux group (irl) ltd operating instructions frost-free cooling and freezing appliance ko-arctis 3193-4ga
Друкувати сторінку
Malfunction
Large accumulation of
frost in the appliance, per-
haps also at the door seal.
Unusual noises.
The compressor does not
start immediately after
pressing the FREEZE but-
ton, or after changing the
temperature setting.
Compressor does not start
after appliance is switched
on.
Only temperatures above
0 °C can be set, although
the appliance should be
used as a freezing unit.
Only temperatures below
0 °C can be set, although
the appliance should be
used as a cooling unit.
Possible cause
Door is not properly sealed
(perhaps after re-hanging
door).
Appliance is not level.
Appliance is in contact
with wall or other objects.
A part at the back of the
appliance, e.g. a tube, is in
contact with another
appliance part or the wall.
This is normal, no error has
occurred.
Within the first 5 minutes
after switching the appli-
ance on, the electronics
initialise a self-test.
The appliance is in the
operation mode "Cooling".
The appliance is in the
operation mode "Freezing".
Something not Working
Remedy
Carefully warm the door
seal with a hand-held hair
dryer at those points which
are not airtight (no warmer
than approx. 50°C). At the
same time, shape the
warmed door seal by hand,
so that it is again properly
seated.
Readjust the front levelling
feet.
Push appliance away a
short distance.
Bend this part away care-
fully if necessary.
The compressor starts after
a period of time.
The compressor is started
automatically, after the
self-test has been com-
pleted.
Selecting the operation
mode "Freezing". For that,
please refer in the "Select
Freezing or Cooling" chap-
ter.
Select the operation mode
"Cooling". For that, please
refer in the chapter "Select
Freezing or Cooling".
27