Kohler K-1164 Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для Ванни Kohler K-1164. Kohler K-1164 44 сторінки. Bath with airjets
Також для Kohler K-1164: Посібник для власників житла (32 сторінок), Посібник для власників житла (29 сторінок), Посібник з монтажу (48 сторінок), Посібник для власників житла (36 сторінок), Посібник з чорнової обробки (4 сторінок), Посібник з монтажу та догляду (21 сторінок), Посібник для власників житла (29 сторінок)

Make sure air actuator tubing is

securely attached to the pump.

Bond in accordance with applicable codes.

NOTE: Pump model illustrated may differ from your

actual product.

8. Make Electrical Connections

WARNING: Risk of electrical shock. To reduce the risk of electrical shock, connect the pump to a

properly grounded Ground-Fault Circuit-Interrupter (GFCI). This will provide additional protection

against line-to-ground shock hazard. A 120 V, 15 A dedicated circuit is required.

WARNING: Risk of electrical shock. Make sure the power has been disconnected before performing

the following procedures.

Locate and secure the supplied junction box a minimum of 1-1/2" (3.8 cm) above the subﬂoor.

The whirlpool controls and system have been prewired at the factory. A licensed electrician should

make a routine service connection to the junction box.

Connect service to the junction box. The 60 Hz model junction box contains black and white wires

and a ground lug.

A 120 V, 15 A dedicated circuit is required. Provide a Class A Ground-Fault Circuit-Interrupter

(GFCI).

Provide a separate equipment grounding conductor for the inside ground or ground lug. The

conductor must not be connected to any current-carrying conductor.

Bond in accordance with national and local codes.

1010914-2-D

Pump

Electrical

Cord

Junction box should be

wired as shown.

Ground

Neutral

(White)

Electrician to

provide suitable

Neutral

strain relief.

Wire Connectors

From Pump

Line

(Black)

Line

Kohler Co.