Aqua Flo 160198 Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Системи фільтрації води Aqua Flo 160198. Aqua Flo 160198 4 сторінки. High-flow whole house filtration system

Друкувати сторінку

SYSTEM SPECIFICATIONS

Maximum Water Pressure: 85psi (8.6 bar)

Maximum Water Temperature: 100°F (38°C)

Inlet/Outlet Connections:

160197: 3/4" (19.05mm) NPT

160198: 1" (25.4mm) NPT

Maximum Flow Rate: up to 8 gpm

Filter Cartridge Life Span

Cartridges should be changed at least every 6 months or sooner

depending on incoming water quality.

Replacement Filters

ITEM #

FREQUENCY

36287

6 Months

36091

6 Months

Notice to Installer

 Do not discard this manual after installation. This manual contains

important operation, maintenance and precautionary information.

Please present this manual to the user/owner/operator after

installation.

 It is strongly suggested that you read this manual before installing

the system to ensure the best possible installation.

 Installation must comply with all local and state plumbing codes

and regulations.

 Connect the system to cold water supply only. Water temperature

cannot exceed 100°F (38°C).

 System must be installed in a vertical, upright, and level position.

 Do not use with water that is microbiologically unsafe or of

unknown water quality.

 Notice to user/owner/operator: please retain this manual for a

future reference for parts, maintenance, or troubleshooting.

 It is recommended that all personnel responsible for operation

and maintenance of this product read the precautions,

maintenance, and operations section of this manual.

FILTER

DESCRIPTION

P-PMB-5-20BV,

Sediment

4.5" X 20", 5 Micron

Carbon

P-RF-20BV, 4.5" X 20

Installation Precautions

 Do not install system on line pressure above 85psi. If water pressure

is over 85psi (8.6 bar), Canature WaterGroup recommends the

installation of a pressure regulator.

 Do not install the system on a hot water line. Failure to limit the

water temperature to 100°F (38°C) can result in housing failure and

property damage.

 Do not connect the system backwards with the feed water line

connected to the outlet.

 Do not use liquid pipe thread compounds for threaded connections.

Use Teflon® tape only.

 Do not allow the system to freeze. Turn off water supply and drain

the system if temperature falls below 32°F (0°C).

 Do not install system in direct sunlight or where the system will be

exposed to harsh chemicals or may be subjected to being hit by

moving equipment, carts, mops, or any other item that may cause

damage.

 Allow 3" (76mm) minimum clearance under the housings for filter

replacement.

 If water hammer is evident, install water hammer arrestors before

the system.

 Do not overtighten fitting connections.

 Always back off fittings with a wrench when installing fittings to

avoid overtightening or loosening existing fittings.

 Do not install the unit behind equipment where it may be difficult to

access the system for future filter replacements.

Position the system in a suitable location. The direction of flow

through the system is left to right. Keep this in mind when determining

installation locations. Do not mount the system near any source

of heat. Also, do not mount this system over anything that may be

adversely affected by water.

DIMENSIONS

Height: 27.5"

Width: 16.25"

Depth: 8"

16.25"

kg/cm

psi