A.M.Leonard WB6 Посібник із швидкого старту

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Візок на відкритому повітрі A.M.Leonard WB6. A.M.Leonard WB6 4 сторінки. Poly tray wheelbarrow

Друкувати сторінку

WB6 - Pneumatic Tire Model

FWB6 - Flat Free Tire Model

The wheelbarrow consists of four main shipping components:

tray, handles, component box, and wheel assembly. Please check

to make sure that all parts have been included from the parts list.

Clear a flat work surface and allow room to assemble the wheel-

barrow.

Suggested tools: Wide Flat Screw Driver, Socket Driver with 13mm

Deep Socket, Electrical or Duck Tape.

For any questions contact customer service at 800-543-8955

NOTE:

Install hardware only by hand tightening until instructed to com-

pletely tighten.

Step 1)

Install Tray Bolts - Insert the (4) 3" square shank bolts through the

bottom tray holes and (2) 3/4" square shank bolts through the front

tray holes. Then secure bolt heads with electrical tape or duck tape.

Lay the tray upside down on a flat work surface.

Step 2)

Install Tray Supports - Place the #WB1009 Front Tray Support

and #WB1010 Rear Tray Support over the bolts that are extended

through the tray bottom. Raised surface away from bottom of tray.

ASSEMBLY

Step 3)

Install Handles - Position the #WB1004 Handles over the tray bolts.

Step 4)

Install Both Legs - Place a #WB1003 Leg over one handle and bolts,

then secure with Serrated Flange Nuts. Then install the second leg

Step 5)

Install Leg Brace -Keeping the #WB1002 Leg Brace to the inside of

the Leg, line up holes in Brace and Legs, then secure using (4) 3/4"

Slot Head Bolts, washers, and nylon lock nuts.

Holes

toward

rear