Avsl 160.462UK Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Ді-джейське обладнання Avsl 160.462UK. Avsl 160.462UK 6 сторінок. Bubble/haze machine
Introduction
Thank you for choosing the ORB-400 bubble/haze machine for stage and events special effects. This product
is designed to produce bubbles, haze or a combination of both for atmospheric special effects. Please read
these instructions in full to gain the best results from this item and avoid damage to the unit through misuse.
Unpacking
Your ORB-400 should reach you in good condition and should be supplied with IEC mains lead(s), wired
remote timer control, wireless plug-in receiver and keyfob remote.
If there are any signs of damage or items missing from the packaging, contact your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on areas other than the fluid bath or tank, disconnect the mains, allow the ORB-400 to
dry out and have it checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case.
Allow the ORB-400 to acclimatize to room temperature before operating.
Refer all servicing to qualified service personnel.
Placement
The ORB-400 has built-in fluid containers and should be operated in an upright position.
Ensure that the ORB-400 is positioned on a stable, non-slip surface.
Safety
Check for correct mains voltage and condition of IEC lead before connecting to power outlet
Check the condition of the remote lead and ensure that it is not trapped
This unit must be earthed
This unit uses a heating element – be aware that parts of the housing may be hot whilst in use!
Cleaning
Use a soft dry or slightly damp to clean the casing
Do not use strong solvents for cleaning the unit
Clean the haze mechanism periodically by operating with distilled water instead of haze fluid
It is also recommended to use fog machine cleaning fluid (160.670UK) periodically
The bubble fluid bath can be cleaned by rinsing with water, draining through the rear panel tap
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
160.462UK User Manual