Dell EMC VxFlex Ready Node R840 Посібник користувача - Сторінка 34
Переглянути онлайн або завантажити pdf Посібник користувача для Зберігання Dell EMC VxFlex Ready Node R840. Dell EMC VxFlex Ready Node R840 44 сторінки.
Друкувати сторінку
System diagnostics and indicator codes
Table 25 iDRAC Quick Sync 2 indicators and descriptions (continued)
iDRAC Quick Sync 2 indicator
code
Solid amber
Blinking amber
iDRAC Direct LED indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC
subsystem.
You can configure iDRAC Direct by using a USB-to-micro USB (type AB) cable, which you can connect to your laptop
or tablet. The following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Note:
The internal USB is not supported on VxFlex appliance R840.
Table 26 iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Solid green for two
seconds
Flashing green (on for two
seconds and off for two
seconds)
Turns off
NIC indicator codes
Each NIC on the back of the system has indicators that provide information about the activity and link status. The
activity LED indicator indicates if data is flowing through the NIC, and the link LED indicator indicates the speed of the
connected network.
Figure 7 NIC indicator codes
1.
Link LED indicator
2.
Activity LED indicator
The NIC indicators table describes different NIC indicator codes and condition of the connectivity.
R840xd Owner's Guide
34
Condition
Indicates that the system is in fail-safe
mode.
Indicates that the iDRAC Quick Sync 2
hardware is not responding properly.
Condition
Indicates that the laptop or tablet is connected.
Indicates that the laptop or tablet connected is recognized.
Indicates that the laptop or tablet is unplugged.
Corrective action
Restart the system. If the problem persists, see
Getting help
on page
43.
Restart the system. If the problem persists, see
Getting help
on page
43.