Dell D18M Налаштування та технічні характеристики - Сторінка 23
Переглянути онлайн або завантажити pdf Налаштування та технічні характеристики для Перемикач Dell D18M. Dell D18M 39 сторінок. Remote power switch
Також для Dell D18M: Посібник користувача (45 сторінок), Посібник з налаштування та технічних характеристик (39 сторінок), Посібник з монтажу (11 сторінок)
System information
Table 20. System Configuration
Option
Integrated NIC
SATA Operation
Drives
Smart Reporting
USB Configuration
Front USB Configuration
Rear USB Configuration
USB PowerShare
Audio
Dust Filter Maintenance
Description
Allows you to control the on-board LAN controller. The option 'Enable UEFI Network Stack' is not
selected by default. The options are:
•
Disabled
•
Enabled
•
Enabled w/PXE (default)
NOTE:
Depending on the computer and its installed devices, the items listed in this
section may or may not appear.
Allows you to configure the operating mode of the integrated hard drive controller.
•
Disabled = The SATA controllers are hidden
•
AHCI = SATA is configured for AHCI mode
•
RAID ON = SATA is configured to support RAID mode (selected by default)
Allows you to enable or disable the various drives on-board:
•
SATA-0
•
SATA-4
•
M.2 PCIe SSD-0
This field controls whether hard drive errors for integrated drives are reported during system startup.
The Enable Smart Reporting option is disabled by default.
Allows you to enable or disable the integrated USB controller for:
•
Enable USB Boot Support
•
Enable Front USB Ports
•
Enable Rear USB Ports
All the options are enabled by default.
Allows you to enable or disable the front USB ports. All the ports are enabled by default.
Allows you to enable or disable the rear USB ports. All the ports are enabled by default.
This option allows you to charge the external devices, such as mobile phones, music player. This
option is enabled by default.
Allows you to enable or disable the integrated audio controller. The option Enable Audio is selected
by default.
•
Enable Microphone
•
Enable Internal Speaker
Both the options are selected by default.
Allows you to enable or disable BIOS messages for maintaining the optional dust filter installed in your
computer. BIOS will generate a pre-boot reminder to clean or replace the dust filter based on the
interval set.
•
Disabled (default)
System setup
23