Dell S4100-ON Series Посібник з монтажу - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Dell S4100-ON Series. Dell S4100-ON Series 47 сторінок.
Також для Dell S4100-ON Series: Посібник з налаштування (21 сторінок), Посібник з монтажу (48 сторінок), Посібник з монтажу (49 сторінок)

The cabinet must meet minimum size requirements. Airflow must be in accordance with the Electronic Industries Alliance (EIA) standard.

Ensure that there is a minimum of 5 inches (12.7 cm) between the intake and exhaust vents and the cabinet wall.

Rack mounting

When you prepare your equipment rack, ensure that the rack is grounded. Ground the equipment rack to the same ground point the power

service in your area uses. The ground path must be permanent.

Dell EMC recommends grounding your switch. Use the S4100–ON Series switch in a CBN.

The fans on the S4100–ON Series (S4128F-ON and S4148F-ON) support two airflow options: normal and reverse.

Fan installation is done as part of the factory install based on SKU type. The S4100–ON Series has stock keeping units (SKUs) that support

the following configurations:

•

AC PSU with fan airflow from the I/O to the PSU—normal

•

AC PSU with fan airflow from the PSU to the I/O—reverse

•

DC fan unit with airflow from the I/O to the PSU—normal

•

DC fan unit with airflow from the PSU to the I/O—reverse

Be sure to order the fans suitable to support your site's ventilation. Use a single type of airflow fan in your switch. Do not mix reverse and

normal airflows in a single switch.

For proper ventilation, position the S4100–ON Series switch in an equipment rack or cabinet with a minimum of 5 inches (12.7 cm) of

clearance around the exhaust vents. The fan speed varies based on internal temperature monitoring. The switch never intentionally turns

off the fans.

For more information, see Fans.

Connect the switch to the applicable power source using the appropriate power cable. An AC power cable is included with the system.

When installing AC or DC switches, follow the requirements of the National Electrical Code ANSI/NFPA 70, where applicable.

The switch is powered-up when the power cable is connected between the switch and the power source.

For more information, see

Power

CAUTION:

Always disconnect the power cable before you service the power supply slots. The switch has multiple power cords.

Before servicing, ensure all power cords are disconnected.

CAUTION:

On the AC switch, use the power supply cable as the main disconnect device. Ensure that the socket-outlet is

located/installed near the equipment and is easily accessible.

NOTE:

Module power is software controlled. You do not see module LEDs when the switch powers up in ONIE.

supplies.

Site preparations