Avyna Pro-Line Поради щодо встановлення - Сторінка 2

Переглянути онлайн або завантажити pdf Поради щодо встановлення для Спорт & на свіжому повітрі Avyna Pro-Line. Avyna Pro-Line 3 сторінки. 12 & 14-foot in-ground trampoline

Друкувати сторінку

Step 5 – As shown in the video, find the center of where the trampoline is to be installed and mark a circle that is two

feet shorter than the trampoline size. The circle inside of the14-foot trampoline will be 12-feet in diameter, one foot

inside the stakes you have just installed – for a 12-foot trampoline, 10-feet in diameter.

Step 6 – Now you may begin the excavation. The bottom of the finished excavation should be a minimum of 26-inches

from the original ground level. The sides should slope into the excavation at an angle of 30 to 45 degrees leaving a flat

circle in the center of the excavation that is a minimum of 26-inches deep and from four to eight feet in diameter,

depending on the slope angle of the sides. NOTE: IF YOU ARE EXPECTING EXCESSIVELY HEAVY OR AGGRESSIVE

JUMPERS, YOU SHOULD ADD SEVERAL ADDITIONAL INCHES OF SAFETY DEPTH TO THIS MINIMUM. A bed of gravel

several inches thick along the flat bottom of the excavation will assist in water absorption and drainage. See diagram

below.

Step 7 – When the excavation has been properly prepared as above, place the frame onto and into the eight stakes in

the ground.

Step 8 – Install the trampoline bed and springs. The bed with the Avyna logo on top should be placed to where the four

spring loops attached with BLUE straps match the four black circles on the frame – at the 90, 180, 270, and 360 degree

points. At these four points, the first four spring should be used to attach the bed to the frame putting the red point of

the spring to the bed – NOT ON THE FRAME. The remainder of the springs should be attached, using the spring tool

provided, putting each spring in the middle of the space between the original four springs, repeating this process until all

the springs are attached. This process keeps from overloading one side of the bed with too many springs and making it

difficult to pull the opposite side to the frame.

Step 8 – If you aligned the dots on the frame with the blue spring straps on the bed, then you will find a small loop on

the underside of the bed under the blue strap. To attach the pad, take the three-clip bungee cord and slip the center

clip through a loop on the bottom of the pad and snap this clip-on small loop on the bed. Attach the two clips on the

ends of the bungee cord to the grommets on the pad that surround the frame. To simplify this process, locate these

loops (there are eight of them on the pad and eight on the bed) before trying to attach the pad at each of the eight

vertical uprights on the frame.

Step 9 – There are 24 wire pad anchors which attach the bottom of the pad to the ground. This keeps miscellaneous

items from getting under the trampoline. Put the wire anchor through the round grommet and lightly drive the wire

anchor with a rubber mallet to ground level.

Step 10 – Your trampoline is now ready for you and your family to jump on it.