HP 6000 - ProLiant - 128 MB RAM Посібник з налаштування утиліти - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з налаштування утиліти для Робочий стіл HP 6000 - ProLiant - 128 MB RAM. HP 6000 - ProLiant - 128 MB RAM 19 сторінок. F10 utility business pcs
Також для HP 6000 - ProLiant - 128 MB RAM: Посібник користувача (20 сторінок), Список підтримки (34 сторінок)
Друкувати сторінку
Table 4
Computer Setup—Security (continued)
Option
Network Service Boot
System IDs
DriveLock Security
System Security (some
models: these options
are hardware
dependent)
ENWW
Description
Enables/disables the computer's ability to boot from an operating system installed on a network
server. (Feature available on NIC models only; the network controller must be either a PCI expansion
card or embedded on the system board.)
Allows you to set:
●
Asset tag (18-byte identifier), a property identification number assigned by the company to the
computer.
●
Ownership tag (80-byte identifier) displayed during POST.
●
Chassis serial number or Universal Unique Identifier (UUID) number. The UUID can only be
updated if the current chassis serial number is invalid. (These ID numbers are normally set in
the factory and are used to uniquely identify the system.)
●
Keyboard locale setting (for example, English or German) for System ID entry.
Allows you to assign or modify a master or user password for hard drives. When this feature is
enabled, the user is prompted to provide one of the DriveLock passwords during POST. If neither
is successfully entered, the hard drive will remain inaccessible until one of the passwords is
successfully provided during a subsequent cold-boot sequence.
NOTE:
This selection will only appear when at least one drive that supports the DriveLock feature
is attached to the system. You may need to power-cycle the system and re-enter F10 Setup in order
to manage DriveLock passwords.
See the Desktop Management Guide for more information.
Data Execution Prevention (some models) (enable/disable) - Helps prevent operating system
security breaches.
PAVP (Some models) (disabled/min) - PAVP enables the Protected Audio Video Path in the Chipset.
This may allow viewing of some protected high definition content that would otherwise be prohibited
from playback.
Virtualization Technology (some models) (enable/disable) - Controls the virtualization features of the
processor. Changing this setting requires turning the computer off and then back on.
Virtualization Technology Directed I/O (some models) (enable/disable) - Controls virtualization DMA
remapping features of the chipset. Changing this setting requires turning the computer off and then
back on.
Trusted Execution Technology (some models) (enable/disable) - Controls the underlying processor
and chipset features needed to support a virtual appliance. Changing this setting requires turning
the computer off and then back on. To enable this feature you must enable the following features:
●
Embedded Security Device Support
●
Virtualization Technology
●
Virtualization Technology Directed I/O
Embedded Security Device Support (some models) (enable/disable) - Permits activation and
deactivation of the Embedded Security Device. Changing this setting requires turning the computer
off and then back on.
NOTE:
To configure the Embedded Security Device, a Setup password must be set.
Reset to Factory Settings (some models) (Do not reset/Reset) - Resetting to factory defaults will
erase all security keys. Changing this setting requires turning the computer off and then back on.
CAUTION:
The embedded security device is a critical component of many security schemes.
Erasing the security keys will prevent access to data protected by the Embedded Security Device.
Choosing Reset to Factory Settings may result in significant data loss.
Computer Setup (F10) Utilities
7