HP 8280 Посібник з техніки безпеки та нормативної інформації - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з техніки безпеки та нормативної інформації для Робочий стіл HP 8280. HP 8280 32 сторінки. Safety and regulatory information
Також для HP 8280: Початок роботи (19 сторінок), Номери телефонів служби підтримки (19 сторінок)
Друкувати сторінку
The requirements listed below are applicable to all countries:
1.
The power cord must be approved by an acceptable accredited agency responsible for evaluation
in the country where the power cord set will be installed.
2.
The length of the power cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). For a power
cord 2.0 m (6.56 feet) or less, the diameter of the wire must be a minimum of 0.75 mm
18AWG. If the power cord is longer than 2.0 m (6.56 feet), the diameter of the wire must be a
minimum of 1.0 mm
The power cord should be routed so that it is not likely to be walked on or pinched by items placed
upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point
where the cord exits from the product.
WARNING!
damaged in any manner, replace it immediately. Damaged cords may result in user exposure to
hazards.
Japanese Power Cord Requirements
For use in Japan, use only the power cord received with this product.
CAUTION:
Pinch Hazard
WARNING!
ENWW
2
or 16AWG.
Do not operate this product with a damaged power cord set. If the power cord set is
Do not use the power cord received with this product on any other products.
Observe pinch hazard areas. Keep fingers away from closing parts.
or
2
Pinch Hazard
5