Miele KM 2354 Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для Варильна поверхня Miele KM 2354. Miele KM 2354 21 сторінка.

Setting the gas pressure

The gas pressure must be set by the

authorised gas fitter as shown on the

data plate:

Natural gas 1.0 kPa

ULPG (Propane/Butane) 2.75 kPa

The gas pressure must be set with the

largest burner operating at maximum

setting.

For ULPG models

a Connection R ¹/₂" with test point

b Connection R ¹/₂" with test point and

90° angle

When using a 90° angle the building-

in depth will increase to the depth of

the elbow used.

11135230-03

For natural gas models

The gas regulator is only included with

appliances which are set up for

connection to natural gas. The

regulator must be connected directly

to the appliance.

a Pressure Test Point

 Loosen the screw in the test point

 Connect the hose from the pressure

 Reassemble one of the large burners,

 Disconnect the hose from the

 For natural gas models: Connect the

until it is free in its housing. The

screw is retained in this position.

gauge.

turn on the gas and manually light the

burners.

pressure gauge and screw in the test

point screw.

gas regulator directly to the

appliance.

Installation