ALLNIC AUDIO M-2500 Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач ALLNIC AUDIO M-2500. ALLNIC AUDIO M-2500 16 сторінок. Px25/300b/kt150 push-pull monoblock power amplifiers
Друкувати сторінку
clockwise slightly to reduce current, in case the bias is set too high for the new tube (since the old tube
may have required additional bias). Bring the bias up gradually to the middle between the two lines on
the meter.
All consequences of changing or attempting to change tubes are borne by the user unless by express
agreement between the owner and an authorized Allnic representative. Allnic Audio and its authorized
representatives are not liable in any way whatsoever for any injury or loss incurred by the user or for
damage to the M-2500s, any of their parts, or tubes or replacement tubes resulting from the user
changing or attempting to change tubes.
SPECIFICATIONS FOR THE ALLNIC AUDIO M-2500s 300B PUSH-PULL MONOBLOCK POWER AMPLIFIER
• Output Power:
• Total Harmonic Distortion:
• Frequency Response:
• S/N Ratio:
• Damping Factor:
• Voltage gain:
• Input Impedance:
• Input Sensitivity:
• Fuses:
• Tubes (per chassis):
• Dimensions:
• PX25: 20w (8Ω load, at 1KHz)
• 300B: 30w (8Ω load, at 1KHz)
• KT150: 100w (8Ω load, at 1KHz)
• Less than 0.01% at 1KHz, 1V RMS
• 20Hz - 50KHz Flat
• -100dB (CCIR, 1KHz)
• 20 at 8Ω load at 1KHz
• +26dB
• 100KΩ (single-ended, unbalanced)
• 0.7V for maximum rated power
• 5A, 250V, 20mm slow-blow (IEC Mains)
• PX25/300B/KT150 X 2 (power tube)
• 6485 X 1 for 300B version; 5654 X 1 for
PX25 and KT150 versions (first stage)
• 12A4 X 2 for PX25/300B versions; 6S4 X 2
for KT150 version (second stage drivers)
• 5U4G X 1 (rectifier - substitute with
equivalent direct-heated rectifier only)
• (W x D x H) 440mm (17.3 inches) x 370mm
(14.6 inches) X 260mm (10.3 inches)
10