Alloy LED PrimaLine Neon 200 TB Інструкція з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Освітлювальне обладнання Alloy LED PrimaLine Neon 200 TB. Alloy LED PrimaLine Neon 200 TB 5 сторінок. 24v led tape light

Друкувати сторінку

Also be sure that the end with the lip is on the correct side.

Refer to the image to the right.

c) Place the Silicone Insert into the gap between the lens and

the diodes. This will ensure a snug connection.

d) Slide the prongs between the PrimaLine Neon Tape Light

and plastic backing. Be sure the prongs are in contact with

the metal connection pads on the back of the PCB of the

tape light (the side without diodes).

To maintain the correct polarity, be sure that the plastic

protrusion on the connector is on the same side as the tape

light diffuser.

Note: If polarity is incorrect, the PrimaLine Neon Tape Light

will not illuminate when connected to power. To correct this,

reverse polarity at the power supply.

e) Secure the metal clamp over the tape light and squeeze

prongs to ensure a tight connection (adjacent to the rubber

washer). Orient the metal clamp so that the notch on the

outside is furthest away from the prongs.

www.AlloyLED.com

page 3 of 5

Installation Instructions

Call: 800.910.LEDS [5337]

Specifications subject to change without notice.

End with Lip

Insert Prongs

Here

Plastic

Backing

Plastic Protrusion

Text: 510.400.6690

[email protected]

Connects to Power

Place Silicone Insert

Here

Diffuser

Notch