ALLPOWER EPW1600 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Мийка високого тиску ALLPOWER EPW1600. ALLPOWER EPW1600 20 сторінок. Electric pressure washer

Друкувати сторінку

ASSEMBLY/OPERATION |

Step 2

(Fig 3)

Insert the adjustable spray nozzle into the gun.

Push and turn the adjustable nozzle clockwise

onto the gun until hand tight to lock it in

place. When the pieces are joined properly,

you cannot separate the two components by

pulling straight out on the adjustable nozzle.

All attachments must be inserted into the gun

for proper use.

(Fig 3)

Step 3

(Fig 4)

Attach the high-pressure hose to the male

fitting on the front of the pressure washer.

Before attaching the high-pressure hose to the

male fitting, remove the plastic cap, which is

inserted onto the fitting before shipping. This

plastic cap can be discarded once removed.

Twist on tight to avoid leakage.

8 | ALL POWER™ EPW1600 POWER WASHER

OWNER'S MANUAL

Step 4

(Fig 5)

Attach the hose connector to pressure washer.

Before attaching the connector to the male

fitting, remove the plastic cap, which is

inserted onto the male fitting on the pressure

washer before shipping. This plastic cap

can be discarded once removed. After both

components have been installed, attach the

garden hose with connector screw on the

pressure washer. Connect the garden hose to

the waterspout.

OPERATING INSTRUCTIONS

NOTE: THIS UNIT IS INTENDED FOR

USE WITH COLD WATER ONLY!

DO NOT USE HOT WATER IN THIS

PRESSURE WASHER.

(Fig 4)

Bleeding The Gun

It is very important to bleed all the air out of

the pressure washer before using it. To do this:

1. Release trigger lock.

2. Squeeze the trigger before turning the

electrical supply on. This removes any air

trapped inside the pressure washer and

lance before using the units.

3. Continue holding trigger for approximately

one minute to allow any excess air out of the

unit. Water will flow through the gun at low

pressure during this procedure.

4. Lock the trigger.

5. Plug the main power cable into the

electricity supply.

6. Release the trigger lock.

7. Turn the ON/OFF switch clockwise to the

I/ON position. The pressure washer is ready

(Fig 5)

to using now.