Miller ArcReach 16 Посібник користувача - Сторінка 39
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller ArcReach 16. Miller ArcReach 16 48 сторінок.
Друкувати сторінку
SECTION 7 – MAINTENANCE AND TROUBLESHOOTING
7-1.
Routine Maintenance
Complete Parts List is available at www.MillerWelds.com
Disconnect power before maintaining.
�
Service equipment more often if used in severe conditions.
Every 3
Months
A complete Parts List is available at www.MillerWelds.com
MAINTENANCE AND TROUBLESHOOTING
� Unreadable Labels
�Damaged Gas Hose
Every 6
Months
� Inside Unit
*To be done by Factory Authorized Service Agent.
7-2.
Overload Protection And Thermostat Protection
�
Complete Parts List is available at www.MillerWelds.com
SECTION 17
17-1. Routine Maintenance
� = Check
◇ = Change
Every
3
Months
�Weld Terminals
1/2 in.
(13 mm)
��Clean And Tighten Weld Connections
� Drive Rolls
1
CB1
Ref. 278794-A
A complete Parts List is available at www.MillerWelds.com
A complete Parts List is available at www.MillerWelds.com
MAINTENANCE & TROUBLESHOOTING
SECTION 17
MAINTENANCE & TROUBLESHOOTING
17-1. Routine Maintenance
� = Clean
Every
3
Months
��Weld Cords And Cables
Weld Terminals
Replace Cracked
� = Replace
Torch Body
Replace Cracked
Torch Body
Repair Or Replace
Cracked Cables And
Cords
Repair Or Replace
Cracked Cables And
Cords
Clean
And
Tighten Weld
Connections
Clean
And
Tighten Weld
Connections
Turn Off wire feeder and welding
power source. Stop engine on
welding generator.
OM-231242 Page 29
1 Supplementary Protector CB1
CB1 protects wire feeder from overload. Cor-
rect problem and reset CB1.
Close and latch door.
Thermostat Protection
Unit has internal thermostat protection and
will not feed wire if overheating occurs (see
Troubleshooting section).
OM-231242 Page 29
OM-278792 Page 33
OM-249336 Page 1