Miller XMT 304 CC/CV Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller XMT 304 CC/CV. Miller XMT 304 CC/CV 40 сторінок. Arc welding power source
Друкувати сторінку
1
2
1
2
OM-233 045 Page 12
3
4
V
2
3
4
1
= < 60°
3
4
5
6
V
>60s
V
219335-C
5
212073-C
179309-C
5
1
Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2
Electric shock from wiring can
kill.
3
Disconnect input plug or
power before working on
machine.
4
Hazardous voltage remains
on input capacitors after
power is turned off. Do not
touch fully charged
capacitors.
5
Always wait 60 seconds after
power is turned off before
working on unit, OR
6
Check input capacitor voltage,
and be sure it is near 0 before
touching any parts.
1
Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2
When power is applied failed
parts can explode or cause
other parts to explode.
3
Flying pieces of parts can
cause injury. Always wear a
face shield when servicing
unit.
4
Always wear long sleeves and
button your collar when
servicing unit.
5
After taking proper
precautions as shown,
connect power to unit.
1
Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2
Falling equipment can cause
injury and damage to unit.
3
Always lift and support unit
using both handles. Keep
angle of lifting device less
than 60 degrees.
4
Use a proper cart to move
unit.
5
Do not use one handle to lift
or support unit.
4/96