Miller Soft Start 1 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальне приладдя Miller Soft Start 1. Miller Soft Start 1 24 сторінки. Om-189 112
Друкувати сторінку
3-5. Installing Gas Supply
Rear view
OM-189 112 Page 8
4
6
5
Argon Gas
7
8
Front view
Obtain gas cylinder and chain to
1
running gear, wall, or other station-
ary support so cylinder cannot fall
and break off valve.
1
Cap
2
Cylinder Valve
Remove cap, stand to side of valve,
2
and open valve slightly. Gas flow
blows dust and dirt from valve.
Close valve.
3
Cylinder
3
4
Regulator/Flowmeter
Install so face is vertical.
5
Gas Hose Connection
6
Flow Adjust
Typical flow rate is 15 cfh (cubic feet
per hour).
Make sure flow adjust is closed
when opening cylinder to avoid
damage to the flowmeter.
7
Gas Input Line
8
Gas Out Fitting
Connect hose from shielding gas
supply regulator/flowmeter to Gas
In fitting.
Connect shielding gas hose from
torch to Gas Out fitting.