Miller Spoolmatic 30A Посібник користувача - Сторінка 20
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальне приладдя Miller Spoolmatic 30A. Miller Spoolmatic 30A 32 сторінки. Welding guns
Також для Miller Spoolmatic 30A: Посібник користувача (32 сторінок), Посібник користувача (36 сторінок)
Друкувати сторінку
7-6. Replacing Diffuser
3
2
1
7-7. Troubleshooting
Trouble
No weld output; gun/feeder does not
work.
Erratic weld output.
Pressing gun/feeder trigger does not en-
ergize weld control; welding wire is not
energized; shielding gas does not flow.
Wire feeds, shielding gas flows, but
welding wire is not energized.
Wire feeds erratically.
OM-1213 Page 16
Tools Needed:
Secure weld control plug in 115 volts AC receptacle (see weld control Owner's Manual).
Place Power switch on welding power source in the On position (see welding power source Owner's
Manual).
Tighten and clean all connections.
Secure plug from gun/feeder trigger cord into 10-socket receptacle on weld control (see Sections 5-4 and
5-5).
Secure control cable leads in weld control (see weld control Owner's Manual).
See Troubleshooting section in welding power source Owner's Manual.
Check and correct drive roll pressure (see Section 5-7).
Clean drive roll or replace drive roll (see Section 7-3).
Decrease spool brake pressure (see Section 5-7).
Turn Off welding power source.
1
Nozzle
2
FasTip
To remove, see Section 7-1.
3
Diffuser
Remove diffuser and replace.
3/8 in.
Remedy
Ref. 803 348-G