aquata Dry Diving Suit Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Водолазний інструмент aquata Dry Diving Suit. aquata Dry Diving Suit 20 сторінок.

turning is enough, besides silicone is in the thread.

If this is not possible, do not go with pliers to the outside valve, besides it is defective. You

must break then on the inside the lower screw connection carefully, so that upper valve

part and thread remain intact. Lower screw connections you receive from our service.

The intake valve is swiveling, you can thus turn the hose arbitrarily to the left or right side.

The valve connection of the hose of the „Sitech" valve is not identical to the connections

for standard Inflator, as the air is specially reduced in this hose therefore the connection

on the inlet valve is different. For your journey you should always take a spare with you.

To dress the suit should always take place with an auxiliary person. Enter with the feet

first, then pull up the suit up to the chest, and enter the arms. When passing the hands

through by the seals do not use high pressure on the seals, (tear danger) slowly push

through. Now pull the neck seal slowly over the head. The best is, if you have a hood

attached, grip with the hands through the front of hood and open the seal wide. Fix the

seal around the neck and pull the hood over. Let another person close the back zipper,

take care that the underall you wear is not between the teeth of the zipper. Never close

the zipper by force. If something stuck in between slowly pull back the slider and hold

the teeth free.

Taking off takes place in reverse order. Treat the seals very careful, slowly pull slider back.

1.2 Care after use

Clean the suit carefully with fresh water after closing the dry zipper. The seals and the

rubber shoes can be sprayed with silicone spray, clean after it the surplus silicone. Hang

the suit in good ventilate room on a wide hanger. Avoid hot lights or direct sunshine.

Seals are not under warranty.

The zipper should be regularly greased with the wax stick. The valves are to a large extent

maintenance-free. Only the intake valve connection and hose should be greased with

silicone.

If seams on the suit open (by reason of damaged by equipment or boat) you can slowly

burn the thread with a lighter and press the melted thread to the suit. Never pull the

thread open.

If you see at the suit woolly brushings, control your equipment, as whether magic tapes

or other hard equipment may damage the suit at this position.

These damages are not covered by our warranty.

The suit should hang after use and not be stored in the travel bag, as the neoprene ma-

terial must recover from the diving.

The valves are normally maintenance free, but you should control after a longer storage or

diving in saltwater if the valves still work perfect. Let a specialist do the checking.

1.3 Repair

Repair is quite rare if the suit is carefully maintenanced. In addition, the best suit will be

defective once (particularly with constant daily work). Usually water break-in with cannot

be seen with naked eyes. Damages of the outer skin, by abrasions, or breaks of the seals

0 3 | EN