AQUATECH ECO 3600 Інструкція користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція користувача для Водяний насос AQUATECH ECO 3600. AQUATECH ECO 3600 12 сторінок. Eco pond series

IMPORTANT about SECURITY!

The installation and operation of ECO pumps may only be carried out

by persons over 16 years, who can understand the text of this users

instructions correctly.

Check that the power supply is identically with the one indicated on the pump.

ECO pumps are provided with 10 m of grounded electrical safety cable and casted

plug. The pump has to be connected to a grounded plug with earth leakage circuit

breaker of 30 mA .

Use only good quality grounded extension leads, flexes, plugs and the like.

For ensuring optimal safety, the cable is casted into the pump housing and cannot be

exchanged. If the cable is damaged, the pump may not be used any longer.

When carrying out activities in or near the water, all devices which are immersed or

in touch with the pond water should be switched off.

The pump may not be lifted or pulled by the power supply cable. Mount an additional

wire to the pump housing to lift the pump out of the water.

The ECO pump is exclusively made for pumping water. Other floating media, burn-

able liquids or water over 40º C may not be pumped.

The ECO pump may not run dry, as this could damage or even destroy the pump.

Possible damages caused by dry run are not covered by the warranty.

The ECO pump has to be installed at least 10 cm and not more than 2 m below the

water level. See the maximum depth on the data sheet of the pump.

The ECO pump has to be placed horizontal and not in the bottom sludge. If neces-

sary you should use an elevation like f. ex. a socket of bricks.

The water temperature may not exceed 40º C, as this can damage the pump. How-

ever the automatic thermal security device will ensure, that the pump will be discon-

nected.

When the pump and its connections are installed and checked completely (there may

not be any air bubbles in the ducts), it can be connected to the power supply.

NB:

Before use: Check that the cable, the socket and the plug are dry and intact.

Caused by safety reasons, repairs at the cable and the pump motor may only be carried

out by the supplier or an authorized electrician (see the certificate of warranty).

When the pump is installed outside the pond (dry-installation), all connections and con-

nection parts have to be watertight and equipped with gaskets. Fasten all connections

and connection parts properly.

The gaskets have a limited lifetime and have to be checked regularly. If the gaskets are

porous or defect, they have to be replaced.

For avoiding overheating, when the pump is installed outside the pond, the hoses /

pipes should have following diameters:

(Use always the hose / pipe with the biggest possible diameter).

ECO

3600 - 4800 min. 25 mm on outlet and 32 mm on suction side

ECO

7200 - 11000 min. 32 mm on outlet and 32 mm on suction side

ECO 14000 - 18000 min. 40 mm on outlet and 40 mm on suction side

ECO 22000 - 25000 min. 40 mm on outlet and 50 mm on suction side