Aquatek ATUN Series Посібник з експлуатації та обслуговування - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з експлуатації та обслуговування для Системи фільтрації води Aquatek ATUN Series. Aquatek ATUN Series 10 сторінок. Upflow neutralizers

Друкувати сторінку

Installation CONT.

5. Filling: After completion of plumbing connections, remove fill-port cap using wrench provided and

pour neutralizer media into mineral tank using funnel provided (see below). DO NOT fill tank above the

line on the side of the media tank.

Overfilling the tank can result in neutralizer media entering the service lines. You may

have been provide more media than is required for the initial fill. Save this extra media

Open inlet valve and then turn water supply back on. Using a garden hose or bucket, fill unit with water

through fill-port. Replace fill-port cap.

6. Flush: Attach a garden hose to boiler drain (if installed) on outlet of the ATUN Series Upflow Acid

Neutralizer System. Discharge of hose should be into a bucket or drain. Open boiler drain and slowly

open inlet valve to flush the ATUN Series Upflow Acid Neutralizer System. Discharge water from hose will

be milky white due to fines generated during shipping and handling. Very fine particles of neutralizer

media may also be observed in the water. If "sand" like particles are observed, reduce flush flow rate

and then gradually increase. Continue to flush until discharge water runs clear. Upon completion of

flushing, close boiler drain and bypass valve and open outlet valve

7. IMPORTANT: If the home utilizes a tankless water heater, it is recommended that a water softener be

installed following the the ATUN Series Upflow Acid Neutralizer System. If the pH is initially over correct-

ed, the inlet bypass can be partially closed to mix untreated water with treated water to achieve the

desired level.

***Disclaimer*** United Water strongly recommends that each system be installed by a

licensed and knowledgeable professional. Failure to do so could result in property dam-

All systems MUST be installed in accordance with local and state plumbing codes.

Mainternance & Replenishing/Filling MEDIA:

The media in this the ATUN Series Upflow Acid Neutralizer System

is sacrificial, therefore it must be replenished periodically. The

frequency is dependent on the raw water pH and your water

consumption habits. The lower the pH and the higher the water

usage, the more frequently replenishment will be required. One

easy way of determining when to replenish is by placing a mark

on the outside of the tank at the level of the media when first

installed. Periodically shine a bright light through the tank and

compare the current level to the mark, if it is down more than

two (2) inches, add media to the mark. If you are unable to see

through the tank, remove the fill-port cap and measure down

to the top of the media. The tank should be 2/3 full. If not, add

media.

1) Close inlet and outlet valves. Open bypass valve so untreated

water can still be used during the replenishment operation.

2) Open boiler drain to relieve pressure. Remove fill-port cap

using wrench provided, some water will drain out of the fill-port

opening. Use a flexible tube to siphon approximately two gallons

of water from the tank.

3) Using the funnel provided, add the required amount of me-

dia, not to exceed the indicated line on the media tank. A bright

light may be placed behind the tank to observe the media level.

4) Refer to Steps 8-9 in Section 2 for flushing instructions to

complete the replenishment operation.

for future replenishment.

age, equipment failure and potentially void warranty.

UNITED WATER INC.

AtuN-S

quAtek

erieS

Ser

uide