Diatip CD 600 Economy Посібник оператора - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник оператора для Токарний верстат. Diatip CD 600 Economy. Diatip CD 600 Economy 13 сторінок. Retipping system
Друкувати сторінку
Midhage Diatip AB
OPERATING INSTRUCTIONS and HOW TO CUT OFF THE
WORN PART OF THE DRILL BIT AND MAKE NOTCHES
Segment guide
2
Index pin holder
1
1
Decide the number of segments that
should be rebrazed on the new rim of the
core bit. Adjust the index pin holder on
the scale that positions the pin over the
index plate. (Refer to the segment guide
located at the end of this manual).
2
Select the side (A or B) of the indexing
plate that corresponds to the core bit
dimensions.
Index plate – this image shows side B
Make sure the surfaces are clean before
placing the index plate on the blank base
plate. Then place the index pin holder in
position over the index plate.
When mounting the core bit the guide pin
should always lay in one of the holes of
the Index plate
3
Lock the core bit by sliding the core bit
attachment to the end of the slides
(opposite from cutter head). Then twist
the barrel clockwise until the level (1) in
the bottom reach the stop bolt (2). Turn
the barrel so it is fasten properly on to the
core bit attachment. When demounting
the barrel do the same procedure but the
opposite way
May 2003
4