Diatip CD 600 Economy Посібник оператора - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник оператора для Токарний верстат. Diatip CD 600 Economy. Diatip CD 600 Economy 13 сторінок. Retipping system
Друкувати сторінку
Midhage Diatip AB
CHANGING THE MATRIX AND KNIFE
1
2
3
Guide Pin
4
5
Remove the existing matrix by turning the
handle counter clockwise. Place the
cutting handle so that the blade stays in
its back position.
Loosen the allen screw which holds
existing blade. Pull it out and replace with
the new cutting blade and re-tighten.
Insert the new matrix. If the replacement
matrix and blade is the 16 mm or 20 mm
size the arrow on the top must then point
to the "D" position. Tighten the handle.
Be sure that the guide pin in the bottom of
the cutter head fits into the hole on the top
of the matrix.
By moving the cutting handle back and
forward, check to make sure that the
blade slides accurately into the matrix and
tighten the handle clockwise.
May 2003
7