Epson Artisan 700 Series Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Принтер Epson Artisan 700 Series. Epson Artisan 700 Series 11 сторінок. Using the control panel for wireless network installation
Також для Epson Artisan 700 Series: Посібник з встановлення мережі (41 сторінок), Важлива інформація про налаштування (3 сторінок), Посібник користувача (34 сторінок), Посібник користувача (38 сторінок), Технічні характеристики (2 сторінок), Посібник із швидкого старту (8 сторінок), Бюлетень підтримки продукту (5 сторінок), Посібник з експлуатації (28 сторінок), Питання (4 сторінок)

Epson Artisan 700 Series Посібник користувача
3. Insert all four batteries into the compartment, positioning
the + and – ends as shown:
4. Close the battery cover and slide it to the right while
pressing down, until it snaps into place.

Handling Batteries

If you forget to charge your NiMH rechargeable batteries or
they need to be replaced, the camera can also accept the
following:
Rechargeable AA NiCad batteries
Single-use AA alkaline batteries (Energizer
recommended)
Single-use AA lithium batteries (longer life)
WARNING
To avoid the danger of fire or explosion, do not mix different types of
batteries. Replace all four batteries at the same time. Do not allow
the battery contacts to touch metal objects such as coins or keys,
which could short out the battery's circuits. Charge your NiMH
batteries only with the EPSON NiMH battery charger (Model EU-23).
Do not put in fire or water, drop or apply pressure, disassemble,
short-circuit, or apply heat. Keep away from small children. If battery
acid gets into your eyes or on your skin, immediately rinse the
affected area well with water and seek medical treatment. If a battery
is swallowed, seek medical treatment immediately.

Using the Display Panel

The display panel shows the camera's current settings, the
status of your batteries (when power is low), and the number
of pictures remaining.
.
approximate
pictures
remaining
image
quality and
mode

Checking the Battery

flashes when your battery power is completely out.
To save battery power, the camera shuts off automatically after
60 seconds. It also shuts off when you take a picture with the
LCD screen. To turn the camera back on, press the shutter
button all the way down or close the lens cover and then open
it again.
You can change the battery saving mode to have the camera
remain on after you take a picture with the LCD screen.
However, you'll use up your batteries faster. You can also
change the auto shut-off time period, or press the shutter
button to turn the camera back on.
Flash
®
brand
The camera's built-in flash is effective within a range of
8 inches to 8 feet (20 cm to 2.4 m). Press the flash button to
cycle through the three flash settings. An icon for each setting
appears on the display panel as shown below:
Auto
AUTO
Flash Off
Forced Flash
5/98
low battery icon
When your battery power is almost out, the low
battery icon appears on the display panel. The icon
The flash goes off automatically whenever it's needed
for adequate lighting (factory setting).
The flash is disabled, even when adequate lighting is
not available. Use this setting for special effects, where
flash photography is prohibited, or for macro mode
close-ups.
The flash goes off with every picture you take. Use this
setting to compensate for backlighting; for example,
when you are facing a light source.
EPSON PhotoPC 700
flash
mode
macro
mode
timer
EPSON PhotoPC 700
- 5