Ayra ALO 019 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Сканер Ayra ALO 019. Ayra ALO 019 10 сторінок. Dual led scanner
Також для Ayra ALO 019: Посібник користувача (13 сторінок)
Друкувати сторінку
Setting up the unit
To activate the unit, connect the included power supply with the unit and a suitable 230V, 50 Hz power
outlet. The unit will activate directly after it is plugged in to a wall outlet or other power source.
With the dipswitch panel, it is possible to change the DMX-address of the fixture, but it is also possible
to change the working mode.
The following dipswitch-positions trigger certain working modes:
The several working modes explained:
Auto run mode:
The fixture will run its automatic internal program on a predefined speed.
Sound active mode:
The fixture will run its automatic internal program on the beat of the music, with the built-in
microphone. The microphone sensitivity is adjustable with a potentiometer, located at the bottom of
the fixture, below the microphone.
Please note that the fixture will not (properly) respond to high frequencies. It is also possible that
speakers are placed too far away from the fixture, which may cause non-responsive behavior in
relation to the music.
Master/slave mode:
It is possible to connect several ALO 019 fixtures with standard XLR – XLR cables, without the use of
a DMX-controller. In this mode, the first fixture in the chain will perform as master (in the automatic or
music controlled mode). The other fixtures in the chain, set to slave-mode, will mimic the performance
of the first fixture, for synchronized lightshows.
DMX-512 mode:
With this feature, you have full control over the functions of the ALO 019 dual LED scanner. This
requires a DMX controller or DMX software.
A full description of the DMX channels and values for certain actions can be found on the next page of
this product manual.
5