Siemens EH FE Series Інструкція з експлуатації - Сторінка 13

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Siemens EH FE Series. Siemens EH FE Series 28 сторінок.

Siemens EH FE Series Інструкція з експлуатації
OTime-setting options
Y our hob has two timer functions:
T i m e - s e t t i n g o p t i o n s

Programming the cooking time

Kitchen timer
Programming the cooking time
The hotplate automatically switches off after the time
that is set has elapsed.
Setting procedure:
Select the hotplate and the required heat setting.
1.
Touch the
0
symbol.
2.
the hotplate.
lights up on the timer display.
‹‹
Within the next 10 seconds, set the required cooking
3.
time in the settings range.
After a few seconds, the time begins to elapse.
The same cooking time can be set automatically
Note:
for all hotplates. The set time for each of the hotplates
counts down independently.
You can find information on automatically programming
the cooking time in section ~ "Basic settings"
Changing or cancelling the time
Select the hotplate and then press the
Change the cooking time using the programming zone
or set to
in order to cancel the time.
‹‹
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The
time program function lights up
the display.
When the
symbol is pressed, the indications turn off
0
and the beeping stops.
Notes
If a cooking time was programmed for several
hotplates, the time information for the selected
hotplate is shown in the timer display.
You can set a cooking time of up to 99 minutes.
x
lights up on the display for
0
symbol.
for 10 seconds in
‹‹

The kitchen timer

You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Programming
Press the
symbol several times until the
0
1.
indicator lights up.
‹‹
function display.
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the
0
symbol several times until the
lights up. Change the time with the programming zone,
or set to
‹‹
.
Once the time has elapsed
A warning signal sounds. In the time program function
display
is shown, and the
‹‹
After 10 seconds the indicators turn off.
When the
symbol is pressed, the indicators turn off
0
and the beeping stops.

Time-setting options

W
lights up in the time program
W
indicator
indicator lights up.
W
en
13