Epson EasyMP Network Projection Посібник з експлуатації - Сторінка 41

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Проектор Epson EasyMP Network Projection. Epson EasyMP Network Projection 50 сторінок. Multimedia projector
Також для Epson EasyMP Network Projection: Посібник з експлуатації (47 сторінок), Інструкція з оновлення (4 сторінок), Посібник з експлуатації (50 сторінок), Посібник з експлуатації (47 сторінок), Посібник з експлуатації (50 сторінок), Посібник з експлуатації (40 сторінок), Посібник з експлуатації (48 сторінок), Посібник з експлуатації (47 сторінок)

Troubleshooting

Check

Is the firewall turned off, or has the firewall been

registered as an exception?

Is Wireless LAN Power set to Off in the Wireless LAN menu

from the projector's Configuration menu?

Is the AirMac setting for Mac OS correct?

Cannot connect in Advanced Connection Mode.

Check

Is the SSID setting different?

Is the same WEP key set?

Are the connection denial functions, such as MAC

Address

restrictions and port restrictions, set correctly at

the access point?

Are the IP address, the subnet mask, and the gateway

address for the access point and the projector set

correctly?

Are the access point and the projector's subnet different? Select Manual search from EasyMP Network Projection, specify the IP address, and connect.

Have you enabled DHCP?

When you do not wish to turn off the firewall or register the firewall as an exception, make the

necessary settings to open the ports.

The ports used by EasyMP Network Projection are "3620", "3621", and "3629".

Set Wireless LAN Power to On in the Wireless LAN menu from the Configuration menu.

See your projector User's Guide for details on the projector's wireless LAN settings.

Check that AirMac is set to on. Or, check whether an appropriate access point has been selected.

Set the computer, the access point, and the projector to the same SSID.

You can make the SSID setting from the projector's Network menu.

See your projector User's Guide for details.

When selecting WEP from Security, set the access point, the computer, and the projector to the same

WEP key.

See your projector User's Guide for details on the WEP key.

Set connection permission at the access point to allow projectors to connect.

When not using a DHCP, adjust each setting.

You can make the DHCP setting from the projector's Network menu.

See your projector User's Guide for details.

s "Specifying Either an IP Address or Projector Name and Performing a Search (Advanced

Connection Mode Only)"

p.17

When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby

status if an available DHCP server is not found.

Remedy