Cisco 3745 Посібник із швидкого старту - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережевий маршрутизатор Cisco 3745. Cisco 3745 33 сторінки. Non-proprietary security policy
Також для Cisco 3745: Огляд рішення (16 сторінок), Інструкції з оновлення (30 сторінок), Посібник користувача (48 сторінок), Посібник з монтажу (12 сторінок)

Step 11 After the following messages appear, press Return to save the basic configuration:

The following configuration command script was created:

hostname 3745

enable secret 5 $1$Ksjf$za4T2lb3ARS5d1PHVzW5A0

enable password xxxx

line vty 0 4

password xxxx

snmp-server community public

no ip routing

interface FastEthernet0/0

no shutdown

media-type 100BaseX

full-duplex

ip address 10.1.1.1 255.255.0.0

interface FastEthernet0/1

shutdown

no ip address

end

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Press RETURN to get started! RETURN

Step 12 The user prompt is displayed:

3745>

When you have completed the basic configuration tasks, your Cisco router is ready to configure for specific functions. See the

"Where to Go Next" section on page 24

Initial Configuration Using the CLI (Manual Configuration)

This section shows how to bring up a command-line interface (CLI) prompt for configuration using the CLI, and it directs you

to documentation for the CLI configuration.You can use the CLI if you see the following messages at the end of the startup

sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file have been installed on the router at the factory. To use

SDM to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on

page 19.

For interface numbering information, see the "Interface Numbering" section on page 22.

for information about locating documentation for advanced configuration procedures.