Cisco 4500-M Посібник з оновлення - Сторінка 20

Переглянути онлайн або завантажити pdf Посібник з оновлення для Мережевий маршрутизатор Cisco 4500-M. Cisco 4500-M 24 сторінки. Upgrading memory
Також для Cisco 4500-M: Посібник з монтажу (18 сторінок), Посібник із заміни (16 сторінок)

Друкувати сторінку
Cisco 4500-M Посібник з оновлення
Memory Replacement Procedures
Caution
damaged by mishandling.
Step 2
Step 3
Figure 15
3.
4.
3.
4.
20 Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory
Handle SIMMs by the edges only. SIMMs are ESD-sensitive components and can be
Hold the SIMM with the polarization notch on the right and the component side away from
you with the connector edge at the bottom.
Referring to Figure 15, insert the Flash memory SIMM at a 45-degree angle and rock it into
its vertical position. (See Figure 8 on page 12.) When the SIMM is properly seated, the
socket guide posts will insert through the alignment holes, and the locking springs will
click into place. Use the minimum amount of force required.
Inserting Flash Memory SIMMs
1. Insert the SIMM into the socket at an angle 45° from vertical.
2. Push the SIMM down and back.
The socket guide posts insert
through the SIMM holes
(on both sides).
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
1. Insert the SIMM into the socket at an angle 45° from vertical.
The socket guide posts insert
through the SIMM holes
(on both sides).
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
Top view
Front of the chassis
Side view
2. Push the SIMM down and back.
Polarization
notch