Cisco 1800 Series Налаштування - Сторінка 22

Переглянути онлайн або завантажити pdf Налаштування для Бездротова точка доступу Cisco 1800 Series. Cisco 1800 Series 32 сторінки. Cisco ios software configuration
Також для Cisco 1800 Series: Посібник із швидкого старту (28 сторінок), Технічний паспорт (16 сторінок)

Друкувати сторінку

How to Configure Radio Settings on an Access Point

DETAILED STEPS

Command or Action

Step 1

enable

Example:

Router> enable

Step 2

configure terminal

Example:

Router# configure terminal

Step 3

interface dot11Radio interface

Example:

Router(config)# interface dot11Radio 0/3/0

Step 4

beacon {period microseconds | dtim-period

period-count}

Example:

Router(config-if)# beacon period 15

Step 5

end

Example:

Router(config-if)# end

Step 6

copy running-config startup-config

Example:

Router# copy running-config startup-config

Configuring RTS Threshold and Retries on an Access Point

Perform this task to set the Request-to-Send (RTS) threshold and number of retries.

The RTS threshold determines the packet size at which the AP issues a request to send (RTS) before

sending the packet. A low RTS Threshold setting can be useful in areas where many client devices are

associating with the access point, or in areas where the clients are far apart and can detect only the AP

and not each other. You can enter a setting ranging from 0 to 2347 bytes.

Maximum RTS Retries is the maximum number of times the AP issues an RTS before stopping the

attempt to send the packet over the radio. Enter a value from 1 to 128.

The default RTS threshold is 2312, and the default maximum RTS retries setting is 32.

Configuring Radio Settings on an Access Point

Purpose

Enables privileged EXEC mode.

Enter your password if prompted.

•

Enters global configuration mode.

Enters configuration mode for the radio interface.

The interface argument is in module/slot/port format,

•

except for the Cisco 800 series and Cisco 1800 series

fixed-configuration routers, where the interface

argument is either 0 or 1.

The 2.4-GHz radio is port 0, and the 5-GHz radio is

•

port 1.

Specifies how often the beacon contains a Delivery Traffic

Indicator Message (DTIM).

Returns to privileged EXEC mode.

(Optional) Saves your entries in the configuration file.