Sony SLT-A58Y Посібник з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Цифрова камера Sony SLT-A58Y. Sony SLT-A58Y 26 сторінок. Interchangeable lens digital camera

Друкувати сторінку

NOTE FOR REPAIR

• Make sure that the flat cable and flexible board are not cracked

of bent at the terminal.

Do not insert the cable insufficiently nor crookedly.

• When remove a connector, don't pull at wire of connector. It is

possible that a wire is snapped.

• When installing a connector, don't press down at wire of con-

nector.

It is possible that a wire is snapped.

• Do not apply excessive load to the gilded flexible board.

DISCHARGING OF THE CHARGING

CAPACITOR (C901)

The charging capacitor is charged up to the maximum 315 V

potential.

There is a danger of electric shock by this high voltage when the

capacitor is handled by hand. The electric shock is caused by the

charged voltage which is kept without discharging when the main

power of the unit is simply turned off. Therefore, the remaining

voltage must be discharged as described below.

Preparing the Short Jig

To preparing the short jig, a small clip is attached to each end of

a resistor of 1 kΩ /1 W (1-215-869-11).

Wrap insulating tape fully around the leads of the resistor to

prevent electrical shock.

1 kΩ/1 W

Wrap insulating tape.

SUBSIDIARY MATERIALS

G: Grease

G-15 (J-6082-619-A)

G-85 (J-6082-626-A)

G-116 (J-6082-628-A)

SLT-A58K/A58M/A58Y_L2

Cut and remove the part of gilt

which comes off at the point.

(Be careful or some

pieces of gilt may be left inside)

Note: High-voltage cautions

Discharging the Capacitor

Short-circuit between two points with

the short jig about 10 seconds.

R: 1 kΩ / 1 W

(Part code: 1-215-869-11)

AM-1001 Board

2-2