Cisco Catalyst 3560-E Series Вказівки щодо встановлення - Сторінка 9

Переглянути онлайн або завантажити pdf Вказівки щодо встановлення для Мережеве обладнання Cisco Catalyst 3560-E Series. Cisco Catalyst 3560-E Series 20 сторінок. Switches and power supply modules
Також для Cisco Catalyst 3560-E Series: Посібник для початківців (25 сторінок), Інформаційний бюлетень про продукцію (5 сторінок), Питання та відповіді (3 сторінок), Бюлетень підтримки продукту (2 сторінок), Бюлетень підтримки продукту (5 сторінок)

Grounding the Switch

Warning

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the

absence of a suitably installed ground conductor. Contact the appropriate electrical inspection

authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Warning

When installing or replacing the unit, the ground connection must always be made first and

disconnected last. Statement 1046

To make sure that the equipment is reliably connected to earth ground, follow the grounding procedure

Caution

instructions.

Follow these steps to install either a single-ground lug or a dual-ground lug on the switch. Make sure to

follow any grounding requirements at your site.

Locate the ground lug screw and the lug ring in the switch accessory kit. For a dual-ground connection,

Step 1

also locate the dual-ground adaptor and the dual-hole lug that ships with the DC power supply module.

If your ground wire is insulated, use a wire stripping tool to strip the 12-gauge or 6-gauge ground wire

Step 2

to 0.5 inch (12.7 mm) ± 0.02 inch (0.5 mm). Use 12-gauge copper ground wire for the single-ground

connection. Use 6-gauge copper ground wire for the dual-ground connection.

Figure 8

Slide the open end of the ground lug over the exposed area of the wire.

Step 3

Using a Panduit crimping tool, crimp the ground lug to the wire.

Step 4

Figure 9

78-17570-01

Stripping the Ground Wire

0.5 in. (12.7 mm) ± 0.02 in. (0.5 mm)

Insulation

Crimping the Ground Lug

Installation Notes for Catalyst 3750-E, Catalyst 3560-E Switches and RPS 2300 Power Supply Modules

Wire lead

Power Supply Module Installation