Cisco SCE8000 GBE Процедури зняття та заміни - Сторінка 32

Переглянути онлайн або завантажити pdf Процедури зняття та заміни для Мережеве обладнання Cisco SCE8000 GBE. Cisco SCE8000 GBE 36 сторінок. 10gbe platform
Також для Cisco SCE8000 GBE: Посібник із швидкого старту (25 сторінок), Посібник з конфігурації (18 сторінок), Встановлення (21 сторінок)

Installing a SPA in a SIP

Figure 9-17

Table 9-1

This number

Installing a SPA in a SIP

To install a SPA in a SIP, see

At the SCE# prompt, enter reload shutdown and press Enter to power down the Cisco SCE 8000

Step 1

platform before installing or removing any module.

To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at

Step 2

the top left and top right of the SPA slot and are recessed about an inch, as shown in

Carefully slide the SPA into the SIP until the SPA is firmly seated in the SPA interface connector. When

Step 3

fully seated, the SPA might be slightly behind the SIP faceplate.

After the SPA is properly seated, fasten the SPA in place with the captive installation screws.

Step 4

Cisco SCE8000 10GBE Installation and Configuration Guide

9-32

illustrates how to install and remove a SPA in the Cisco SCE 8000-SIP.

SPA Installation and Removal

76 00 -S

IP -40 0

SP A INT

ER FA CE

PR OC

ES SO R

SP A- 1X

10G E-L

-V2

SP A- 1X

10G E-L

-V2

Componet Indications

Figure 9-17

Indicates this component

Cisco SCE 8000-SIP

1X10 GBE SPA module

and do the following:

Chapter 9 Removal and Replacement Procedures

Figure

9-17.

OL-26784-02