Cisco UBR7246VXR Встановлення обладнання - Сторінка 10

Переглянути онлайн або завантажити pdf Встановлення обладнання для Мережеве обладнання Cisco UBR7246VXR. Cisco UBR7246VXR 25 сторінок. Universal broadband router
Також для Cisco UBR7246VXR: Посібник із швидкого старту (27 сторінок), Посібник користувача (7 сторінок), Посібник з монтажу (28 сторінок)

Figure 5

Installing the Rack-Mount Brackets so the Front of the Chassis Is Flush with the Rack

Rack-mount bracket

Note

You cannot use the cable management bracket in this configuration.

Figure 6

Installing the Rack-Mount Brackets so the Front of the Chassis Protrudes Out of the Rack

Rack-mount bracket

Attach the Rack-Mount Brackets to the Middle of the Chassis

To install the rack-mount brackets for an open or relay-type rack-mount configurations, complete the following steps:

Step 1

Locate the threaded holes in the middle sides of the chassis.

Step 2

Align the first rack-mount bracket to the threaded holes in the right side of the chassis, as shown in Figure 7. Use either

set of four holes to align the bracket to the threaded holes in the sides of the chassis.

Step 3

Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.

Use a number 2 Phillips screwdriver to tighten the screws.

Step 4

Repeat Step 1 through Step 3 to attach the other rack-mount bracket.

Step 5

See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.

Rack-mount bracket