Cisco Firepower 2130 Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для Сервер Cisco Firepower 2130. Cisco Firepower 2130 12 сторінок. Rack-mount and ground the chassis
Також для Cisco Firepower 2130: Посібник з розгортання (8 сторінок), Початок роботи (42 сторінок), Встановлення та обслуговування (26 сторінок)

Rack-Mount and Ground the Chassis

c) Slide the release clip toward the rear on both inner rails, and then continue pushing the chassis into the rack until the

mounting brackets meet the front of the slide rail.

Figure 8: Inner Rail Release Clip

Inner rail release clip

Step 7

Use the captive screws on the front of the mounting brackets to fully secure the chassis to the rack.

What to do next

• See

• Install the cables according to your software configuration as described in the

Ground the Chassis

Note

Grounding the chassis is required, even if the rack is already grounded. A grounding pad with two threaded

M4 holes is provided on the chassis for attaching a grounding lug. The grounding lug must be Nationally

Recognized Testing Laboratory (NRTL)-listed. In addition, a copper conductor (wires) must be used and the

copper conductor must comply with National Electrical Code (NEC) code for ampacity.

You need the following items that you provide:

• Wire-striping tool

• Crimping tool

Ground the Chassis, on page 9

Getting Started

Guide.

Inner rail attached to chassis

for the procedure to ground the Firepower 2100.

Rack-Mount and Ground the Chassis

Ground the Chassis

Cisco Firepower 2100