Cisco VG202 Посібник з налаштування програмного забезпечення - Сторінка 37
Переглянути онлайн або завантажити pdf Посібник з налаштування програмного забезпечення для Шлюз Cisco VG202. Cisco VG202 50 сторінок. Voice gateways
Також для Cisco VG202: Посібник з встановлення обладнання (50 сторінок), Посібник (10 сторінок), Посібник з встановлення обладнання (48 сторінок), Посібник із швидкого старту (19 сторінок)
Друкувати сторінку
Chapter 4
Configuring Voice
Table 4-1
Port Number
0/0
0/1
0/2
0/3
Configuring Calls
This section provides information and provisions for configuring calls on the VG202 and VG204 voice
gateways. The following functions are covered:
•
•
•
•
Call Transfer
The VG202 or VG204 voice gateways blind-call transfer functionality allows the transfer of a call from
the party you call to a destination caller without and call commit from the original person called. For
example, party A (transferee) calls party B (transferor). The transferor wants to transfer the call to party
C (transfer-target) and uses hookflash (softkey transfer) to get a dial tone, and then dials party C's
number. When CCM gets party C's number, it transfers the party A call to party C without the need of
committment from party B.
The VG202 or VG204 voice gateways consultation call transfer functionality allows happens after a call
is established between a transferor and transferee. The transferor wants to transfer the call to a transfer
target by using a softkey transfer by getting a dialtone then dialing the transfer-target's phone number.
When the call between the transferor and transfer-target is established, the transferor hangs up the phone
to commit the transfer. The CCM connects the call between the transferee and the transfer-target.
To configure call transfer on the voice gateways, use the following commands.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
OL-16191-01
Voice Port to MAC Address Conversion Chart
Last Three Digits of the MAC
Address
000
001
002
003
Call Transfer, page 4-11
Call Waiting, page 4-12
Three-Party Conferencing, page 4-13
Call ID, page 4-13
enable
configure terminal
dial-peer voice tags pots
service stcapp
port port-number
exit
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
Configuring Calls
4-11