Epson P7000 - Multimedia Photo Viewer Основний посібник з експлуатації - Сторінка 15

Переглянути онлайн або завантажити pdf Основний посібник з експлуатації для Аксесуари для принтерів Epson P7000 - Multimedia Photo Viewer. Epson P7000 - Multimedia Photo Viewer 29 сторінок. Surecolor p-series
Також для Epson P7000 - Multimedia Photo Viewer: Бюлетень підтримки продукту (17 сторінок), Брошура та технічні характеристики (6 сторінок), Бюлетень підтримки продукту (28 сторінок), Інструкція з експлуатації (46 сторінок), Інструкція (2 сторінок)

5. Make sure that the Access lamp is off before

removing the memory cards.

6. For a CF memory card, push the eject button twice.

For an SD memory card, push the memory card

down slightly then release, and it will pop up for you

to remove completely.

Note:

❏ Before copying data, charge the battery fully. If the battery

is low, connect the AC adapter. The transfer is canceled if

the viewer's power supply is disconnected during

transfer.

❏ 1 GB of data may take approximately 2 minutes or more to

copy, depending on the memory card you use.

Supported memory card types

CF (CompactFlash) memory card

(Type2 and 3.3 V, including Micro Drive)

SD memory card (up to 2 GB), SD High-Capacity card

MultiMedia Card, MultiMedia Card Plus

Commercially available adapters are required to use

other memory cards (miniSD, microSD, RS-MMC,

Memory Stick Duo, Memory Stick PRO Duo, xD-Picture

Card, and so on). Contact our customer support for

details.

Transferring from a Digital Camera

You can transfer data to the viewer directly from digital

cameras that support the USB Mass Storage

specification.

1. Connect the AC adapter to the viewer.

Note:

When the remaining battery is low on your digital camera,

connect the AC adapter.

2. Open the upper side cover of the viewer and connect

a USB cable to the Host (Standard-A) connector.

Then connect the other end to your digital camera.

3. Turn on the viewer and your digital camera.

Note:

❏ Use the USB cable supplied with your camera to connect.

❏ Do not connect to both of the viewer's USB interfaces

(Host-Standard A and Slave-Mini B) at the same time. It

may cause a malfunction.

Transferring Data to the Viewer