Acuity Controls ECLYPSE A1000 Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу для Реле Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 14 сторінок. Asset tracking
Також для Acuity Controls ECLYPSE A1000: Посібник з монтажу (10 сторінок)

Друкувати сторінку

Acuity Controls ECLYPSE A1000 Посібник з монтажу

1-0 Introduction

1-1 Product Description

This document describes the installation procedures for the ECLYPSE A1000. The ECLYPSE A1000 manages and controls a network of enabled with Atrius

luminaires part of the Atrius Navigator Solution. This programmable device provides advanced functionality, such as customizable IP and WiFi to let you

seamlessly integrate your lighting control system with your building management systems. For more detailed information about the ECLYPSE A1000 and

its capabilities please refer to the ECLYPSE A1000 User Guide.

1-2 General Installation Requirements

For proper installation and subsequent operation of the nLight

Unified Room Interface solution, pay special attention to the following

recommendations:

•

Upon unpacking the product, inspect the contents of the carton

for shipping damages. Do not install damaged modules.

•

Avoid areas where corroding, deteriorating or explosive vapors,

fumes or gases may be present.

•

Ensure the mounting surface can support the controller, DIN rail,

and any user-supplied enclosure.

•

Allow for proper clearance around the controller's enclosure,

and wiring terminals to provide easy access for hardware

configuration and maintenance, and to ventilate heat generated

by the controller.

•

The controller's mounting orientation must be horizontal with

the controller's back attached to a vertical wall surface. Orient

the controller with the ventilation slots and power supply input

terminal block connectors towards the top to permit proper

heat dissipation. When installed in an enclosure, select one that

provides sufficient surface area to dissipate the heat generated by

the controller and by any other devices installed in the enclosure.

A metal enclosure is preferred. If necessary, provide active cooling

for the enclosure.

•

The controller's datasheet specifies the power consumption

(amount of heat generated), the operating temperature range,

and other environmental conditions the controller is designed to

operate under.

•

Ensure that all equipment is installed according to local, regional,

and national regulations.

•

If the controller is used and/or installed in a manner not specified

by Acuity Controls, the functionality and the protection provided

by the controller may be impaired.

Any type of modification to any nLight

product will void the product's warranty.

Take reasonable precautions to prevent electrostatic

discharges to the controller when installing, servicing,

or operating the controller. Discharge accumulated

static electricity by touching one's hand to a well-

grounded object before working with the controller.

1-3 Device Markings (Symbols)

Certain markings (symbols) can be found on the controller and are defined

as follows:

Symbol

Description

CE marking: the device conforms to the

requirements of applicable EC directives.

Double Insulation marking: These controllers are

built using double insulation.

Products must be disposed of at the end of their

useful life according to local regulations.

Read the Hardware Installation Guide for more

information.

For indoor use only.

UL marking: conforms to the requirements of the UL

certification.

FCC marking: This device complies with FCC rules

part 15, subpart B, class B.

Warning Symbol: Significant information required.

Refer to the Hardware Installation Guide.

HIGH VOLTAGE Symbol: Direct contact will cause

electrical shock or burn.

Alternating Current

Direct Current

Line

Neutral

3 of 14