Motorola Radius CM200 Посібник з монтажу - Сторінка 24

Переглянути онлайн або завантажити pdf Посібник з монтажу для Радіо Motorola Radius CM200. Motorola Radius CM200 36 сторінок. Commercial series

Chapter 7

Noise Sources

7.1

Electrical noise generated by the electrical system of a vehicle, as well as local ambient noise, can

interfere with normal operation of mobile radios. Satisfactory operation of a mobile radio may require

slight or heavy noise reduction, depending upon the relative strength of the radio signal, and upon the

ability of the radio to reject undesired noise. These requirements vary from one vehicle to another,

depending upon the vehicle type and required coverage area. When operating in a strong signal area,

a certain amount of noise interference can be tolerated. In weak signal areas, however, noise

reduction becomes very important. As a rule of thumb, noise levels create greatest interference in the

25-50 MHz band and reduce with increasing frequency.

Before attempting any noise reduction procedures, determine the noise source(s). Then, follow a

logical, systematic method of elimination until the interference is eliminated or reduced to an

acceptable level.

CAUTION: Do not add interference elimination equipment to vehicles equipped with

electronic ignition systems before obtaining advice from the vehicle manufacturer. Addition

of some noise suppression components may interfere with proper operation of electronic

ignition systems and could seriously damage them.

Care and patience must be exercised in locating and eliminating noise sources. There may be several

sources of noise, each slightly stronger or weaker than the other. Elimination of one source may seem

ineffective because another noise source remains active at a barely discernible difference in level.

Consult a service manual for the vehicle to determine what noise reduction provisions the

manufacturer applies when AM, AM/FM, or CB radios are installed as original equipment. These

radios are also subject to electrical noise interference, and the manufacturer may install noise

suppression components only upon those vehicles which require radio equipment at the time of

manufacture. These noise suppression components should be added in any first attempt to suppress

noise.

The three major noise sources affecting mobile radio systems are: (1) radiated noise, (2) conducted

noise, and (3) induced noise. (See Figure 7-1 for typical vehicular noise sources.)

7.2

Radiated noise enters the radio through the antenna along with the desired signal and can block or

degrade desired communication. It can be generated by power lines, fluorescent lights, or by

electrical discharges from static build-up, ignition systems, or electrical motors. Radiated noise is the

most common cause of mobile radio interference.

When a spark discharge or arc takes place through air, energy is radiated at frequencies from a few

kilohertz to hundreds of megahertz. This spurious radiation may have some energy radiated at a

frequency near or even identical to the desired radio signal. The standard receiver may be unable to

distinguish between the two signals (desired and noise). Therefore they both enter the receiver,

resulting in degradation of the desired signal.