Toshiba 24 WL3A Series Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для ТЕЛЕБАЧЕННЯ Toshiba 24 WL3A Series. Toshiba 24 WL3A Series 9 сторінок.
Також для Toshiba 24 WL3A Series: Інструкція з експлуатації Посібник з експлуатації (38 сторінок), Інструкція з експлуатації Посібник з експлуатації (45 сторінок)

Inserting the batteries into the remote

Remove the back cover to reveal the battery compartment. Insert two size AAA batteries. Make sure the (+)

and (-) signs match (observe correct polarity). Do not mix old and new batteries. Replace only with same or

equivalent type. Place the cover back on. A message will be displayed on the screen when the batteries are

low and must be replaced.

Connections

Antenna

Connect the antenna cable/s to your TV.

rear side of the TV

Power

After unpacking, allow the TV set to reach the ambient room temperature before you

connect the set to the mains. Plug the power cable to the mains socket outlet.

IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.

In order to turn the TV on from standby mode:

• Press the Standby button, a numeric button or

Programme +/- button on the remote control

• Press the centre of the control switch inwards,

located at the rear left hand side of the TV

satellite

dish

aerial /

cable TV

External Devices

PLEASE ENSURE BOTH UNITS ARE

SWITCHED OFF BEFORE CONNECTING

Use the proper cable to connect two units together.

To select the desired input source, press the Source

button on the remote control. Or press the centre of the

control switch inwards consecutively until the Sources

list is displayed.

HDMI connection

rear of TV

English - 1 -