Whirlpool 3LSR6233EQ1 Посібник з використання та догляду - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник з використання та догляду для Пральна машина Whirlpool 3LSR6233EQ1. Whirlpool 3LSR6233EQ1 39 сторінок.
Друкувати сторінку
TROUBLESHOOTING
C
OMMON WASHING PROBLEMS
Problem...
Washer makes noise
(cont.)
Won't fill/rinse/
agitate or wrong
temperature
Washer stops
Agitator operation
Water level seems
too low or washer
not completely filling
Washer tub is
crooked
16
( CONT
Cause...
•
Gears engaging after drain and
before spin.
•
Upper part of agitator clicks during
wash.
•
Power cord not plugged in.
•
Lid is open.
•
Timer dial is not lined up.
•
Water inlet valve screens are plugged.
•
Water is turned off.
•
Hot and cold hoses are reversed.
•
Inlet hose is kinked.
•
Power cord not plugged in.
•
No power at plug.
•
Fuse blown or circuit breaker open.
•
Using an extension cord.
•
Timer dial is not lined up.
•
Timer knob not pulled out.
•
Washer at pause in Permanent Press
cycle (approximately 2 minutes).
•
Machine is overloaded.
•
The top of the agitator moves only in
one direction.
•
The top of the agitator is loose.
•
The top of the agitator is much higher
than the highest water level. This
creates a perception of the washer not
being full.
•
Tub is pulled forward when unloading.
•
Tub moves.
•
Unit not level.
.
)
Solution...
•
This is normal.
•
This is normal.
•
Plug in power cord.
•
Close the lid.
•
Turn timer knob to the right
slightly and pull to start.
•
Clean screens.
•
Turn on water.
•
Reverse hoses.
•
Straighten hoses.
•
Plug in power cord.
•
Check electrical source or
call electrician.
•
Replace fuse or reset circuit
breaker. If problem continues,
call electrician.
•
Do not use extension cords.
•
Turn timer to the right slightly
and pull to start.
•
Set and pull out knob.
•
Allow cycle to continue.
•
Wash smaller loads.
•
This is normal.
•
This is normal.
•
This is normal.
•
Push tub to center before
starting.
•
This is normal.
•
Ensure front feet are installed
and nuts tightened. Level
washer. Reset rear leveling legs.
See Installation Instructions.