RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the front panel of the range
hood.
B
C
A. Incandescent
light housing and cover
B. Grease filter retainer
C. Grease filter
Range
Hood
Controls
Off
On @
Off
Low@
High
!
!
!
!
A. Fan speed switch
B. On/Off light switch
Operating
the light
Press the light switch to the left to turn the light On.
Press the light switch to the right to turn the light Off.
Operating
the fan
The fan has 2 speeds.
Press the fan switch to the left for Low speed.
Press the fan switch to the right for High speed.
Return the fan switch to the center to turn the fan Off.
RANGE HOOD CARE
IMPORTANT:
Clean the hood and grease filters frequently
according to the following instructions. Replace the grease filter
before operating hood.
Exterior Surfaces:
IMPORTANT:
Do not use soap-filled
scouring pads, abrasive
cleaners, cooktop polishing creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use cleaners that
contain chlorine.
Cleaning
Method:
•
Liquid detergent or all-purpose
cleaner:
Rinse with clean water and dry with a soft, lint-free cloth.
•
Glass cleaner to remove fingerprints.
•
For stainless steel models, rub in the direction of the grain to
avoid scratching
or damaging the surface.
•
For stainless steel models, use Stainless Steel Cleaner
/_
and Polish, Part Number 31462A (not included): See
the "Assistance
or Service" section to order.
Charcoal Grease Filter
To Remove the Filter:
1. Remove the screw from the grease filter retainer.
2. Turn the grease filter retainer to release the filter.
/
//
/
A. Filter retainer
3. For non-vented (recirculating)
installations: The charcoal
filter is not washable. It should last up to 6 months with
normal use. For information on ordering, see the "Assistance
or Service" section. Dispose of the old charcoal filter.
To Replace
the Filter:
1. To reinstall the filter, place the back edge of the filter into the
channel at the rear of the hood. Push the filter into place and
turn the filter retainer to secure the filter to the range hood.
2. Replace the screw in the grease filter retainer.
8
Друкувати сторінку