Alcolock V3 Handset Посібник з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Випробувальне обладнання Alcolock V3 Handset. Alcolock V3 Handset 8 сторінок.

Handset voltage too low

RF error

Software incompatible

Technical error

CALIbRATION pROCEdURES

It is recommended calibration be done indoors in a service facility, using an ACS

download station.

The calibration procedures are intended for use by trained technicians only.

EqUIpMENT NEEdEd

• 130PPM (0.05 %BAC) Alcohol gas standard ACS #95-000425

• Regulator valve assembly (6L/min. flow rate) ACS #94-000225

• V3 Download station ACS #79-006111

COMpRESSEd GAS SAFETY

Calibration should be performed indoors in a service facility, where the gas

standard cylinder can be properly stored.

Transportation and storage of compressed gases in vehicles is dangerous and should be avoided.

Other precautions:

• Never remove or alter canister labels.

• Remove the valve and install the protective cap on cylinders when not in use.

• Store cylinders in a cool, well ventilated area, away from sources of heat.

Voltage is too low for normal

operation.

High levels of RF interference

detected

Firmware in handset and ECU

is not compatible.

Technical problem in the

ECU. One or more fuse(s) is

potentially blown.

1. Check voltage of vehicle

during ignition cranking.

2. Replace ECU.

3. Replace handset.

1. Verify if client was using a

mobile phone or in an area of

high RF signal interference

during use. If yes no action is

required.

2. Replace handset.

1. Verify handset P/N.

2. Verify ECU P/N.

1. Confirm that vehicle voltage

reaching ECU is sufficient.

2. Replace ECU.