Yamaha Arius YDP-105 Посібник користувача - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Yamaha Arius YDP-105. Yamaha Arius YDP-105 24 сторінки.
Також для Yamaha Arius YDP-105: Посилання на міді (3 сторінок)
Друкувати сторінку
Keyboard Stand Assembly
5.
Secure the main unit by tightening
the thick screws (6 × 16 mm).
Main unit
Side board (L)
6.
Connect the pedal cord plug and the
power plug.
Cord holder
6 - 1
TO PEDAL
DC IN
18
YDP-105 Owner's Manual
Side board (R)
× 4
Thick screws
(6 × 16 mm)
6 - 3
6-1
Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
Insert the plug until the metal part disappears
from view.
NOTICE
If it is not plugged in firmly, it may cause the pedals to
not work.
6-2
Wind the cord holders around pedal cord to
hold it.
The cord holders are attached to the side board
(L).
6-3
Insert the DC plug into the DC IN jack.
6 - 2
7.
Rotate the adjuster until it presses in
firm contact with the floor surface.
Make sure that the pedal box does not rattle or
give way when you step on the pedals.
To press against
the floor
After completing the assembly, please check the Post-
assembly checklist (page 16).
Metal part
To separate from
the floor