Yamaha HTR-5130 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Приймач Yamaha HTR-5130. Yamaha HTR-5130 42 сторінки. Natural sound av receiver

Друкувати сторінку
Yamaha HTR-5130 Посібник користувача
SUBWOOFER OUTPUT terminal
This terminal is for connecting to the input terminal of an
amplifier driving a subwoofer.
This terminal outputs low frequencies from the main and center
channels. (The cut-off frequency of signals output from this
terminal is 150 Hz.)
When 6 channel discrete signals are input to this unit and are
selected as the input source, this terminal outputs signals from
the subwoofer channel.

IMPEDANCE SELECTOR switch

Be sure to switch this only when the power to this unit is not
on.
Select the position whose requirements your speaker system
meets.
WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise this
unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/
ON SWITCH IS PRESSED, the IMPEDANCE SELECTOR
switch may not be set to either end closely. If so, set the
switch to either end closely.
<General model>
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN
A OR B: 4 MIN. /SPEAKER
A B: 8 MIN. /SPEAKER
CENTER
REAR
MAIN
A OR B: 8 MIN. /SPEAKER
A B:16 MIN. /SPEAKER
CENTER
REAR
IMPEDANCE SELECTOR
12
OUTPUT
SUB
WOOFER
VOLTAGE SELECTOR
AC OUTLETS
: 6 MIN. /SPEAKER
: 6 MIN. /SPEAKER
: 8 MIN. /SPEAKER
: 8 MIN. /SPEAKER
I00W MAX. TOTAL
SWITCHED
(Left position)
Main:
If you use one pair of main speakers, the impedance
of each speaker must be 4
If you use two pairs of main speakers, the impedance
of each speaker must be 8
Center: The impedance of the speaker must be 6 or higher.
Rear:
The impedance of each speaker must be 6 or
higher.
(Right position)
Main:
<Except for Canada model>
If you use one pair of main speakers, the impedance
of each speaker must be 8 or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 16 or higher.
<Canada model only>
The impedance of each speaker must be 8 or
higher.
Center: The impedance of the speaker must be 8 or higher.
Rear:
The impedance of each speaker must be 8 or
higher.
or higher.
or higher.