Yamaha C525 - NS Center CH Speaker Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система Yamaha C525 - NS Center CH Speaker. Yamaha C525 - NS Center CH Speaker 4 сторінки. Yamaha ns-c525: owners manual
Друкувати сторінку
Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points
on the bottom of the speaker and the top of the TV.
Front
Notes:
•
Do not place the speaker on top of the TV whose area is
smaller than the bottom area of the speaker. If placed,
the speaker may drop out causing an injury to you.
•
Do not place the speaker on top of the TV with an
inclination.
•
Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.
This speaker system is capable of standard connections and bi-wired connections. Before making
connections, make sure that the amplifier is switched off.
<
Standard connections
Leave the short
bars in place
when
connecting.
Short bar
Loosen
Black (–)
Insulation coating
2
E-
PLACING THE SPEAKER
Subwoofer
NS-C525
surround
CONNECTIONS TO YOUR AMPLIFIER
>
Tighten
Red (+)
Bare wire
NS-C525
CENTER
+
–
Amplifier or
Receiver
surround back
•
Thoroughly wipe clean the surface where the fastener is to be
applied. Note that adhesive strength is weakened if the surface is
dirty, oily or wet and that this may cause the center speaker to drop.
•
This speaker features a magnetically shielded design, but
there is still a chance that placing it too close to a TV set
might impair picture color or create a buzzing noise. Should
this happen, move the speaker away from the TV set.
• Connect the screw-type input terminals at the rear of the
speaker to the speaker output terminals of the amplifier
(or receiver) with the speaker cable.
• Connect the (+) terminals on the amplifier (or receiver)
and the speaker using one side of the cable. Connect the
(–) terminals on both components using the other side of
the cable.
• Connect the speaker to the center terminals of your
amplifier, making sure not to reverse the polarity (+, –). If
the speaker is connected with reversed polarity, the
sound will be unnatural and lack bass.
How to connect:
1 Loosen the knob.
2 Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
3 Insert the bare wire.
4 Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Note:
• Do not let the bare speaker wires touch each other as this
could damage the speaker or the amplifier, or both of them.
• Do not insert the insulation coating into the hole.
The sound may not be produced.
1
2
Fastener