Zanussi ZDT26030FA Посібник користувача - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина Zanussi ZDT26030FA. Zanussi ZDT26030FA 21 сторінка.
Друкувати сторінку
Problem and alarm code
The program does not start.
The appliance does not fill with
water.
The display shows
.
The appliance does not drain
the water.
The display shows
The anti-flood device is on.
The display shows
The appliance stops and starts
more times during operation.
The program lasts too long.
The remaining time in the dis-
play increases and skips nearly
to the end of program time.
Small leak from the appliance
door.
The appliance door is difficult
to close.
Rattling/knocking sounds from
inside the appliance.
The appliance trips the circuit-
beaker.
14
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the end of
the countdown.
•
The appliance has started the procedure to recharge the resin
inside the water softener. The duration of the procedure is ap-
proximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
or
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the filter in the outlet hose is not clogged.
•
Make sure that the interior filter system is not clogged.
.
•
Make sure that the drain hose has no kinks or bends.
•
Close the water tap and contact an Authorised Service Centre.
.
•
It is normal. It provides optimal cleaning results and energy sav-
ings.
•
Select the TimeManager option to shorten the program time.
•
If the delayed start option is set, cancel the delay setting or wait
for the end of the countdown.
•
This is not a defect. The appliance is working correctly.
•
The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
•
The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
•
Parts of the tableware are protruding from the baskets.
•
The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
•
Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
Possible cause and solution